ルーター用3.2KW 380V定トルクスピンドルモーター

基礎情報

モデル番号。	GDZ-100-3.5
ローター構造	リスのカゴ
スタートモード	可変周波数から始める
認証	CE
マルケ	初め
輸送パッケージ	合板箱
起源	常州

梱包と配送

製品ユニットごとの梱包サイズ: 99.00 cm * 45.00 cm * 40.00 cm。 製品単位あたりの総重量: 30,000 kg

製品説明

 

Tips before using: for all spindles1.The electric spindle and the frequency inverter shall be suitable with each other.The specifications and parameter settings of the inverter shall match the nominal parameters of the spindles, and it will burm the spindles if the settings are not correct.2.Before using water- cooling spindle, it shall ensure that cooling cycle system works nomarlly and the ruunning under no cooling conditions is prohibited. The volume of cooling water is calculated as per 1 liter/kw, minute, the minimum flow of cooling water is not less than 5 liter/minute ,cooling water pipe and the nozzle shall be connected reliably and there is no leakage.3. The cooling liquid shall be clean and free of grease and the temperature shall be within 5- -30C.The cooling medium shall carry out force cooling when the ambient temperature is higher than 30 C.The precision lathe requires the cooling liquid with a constant temperature of 20±2ºC.4. During storage and transport of the spindle,the status of high- speed grease inside the bearing will change. The user shall run it at a low speed first by starting from the lowest speed of the spindle for 30 minutes and then 20 minutes for every 3000 rounds; otherwise there will have abnormal sound, noise, heat and other phenomena, whitch will affect the bearing life if the spindle is started directly at a high speed. During long term storage, the spindle shall run(at low speed)for 15-30 minutes once a week at least.5.Collect,nut and inner taper hole shall be washed clean when installing blades on the spindle in order to avoid any impact on the precision. The blade handle shall be insterted into the collect more than 1 5mm.6.For daily machining, the spindle shall be warmed up, run for 15- -20 minutes when the machining speed is reached and then performs precise machining.ltis better to stop thespindle for two hours every day in order to recover its mechanical fatigue and prolong its life time.7.No knocking the end cover of the spindle.No hammering the collet and blade head when removing blades. No shocking or colliding during transport, storage and using, especially the end of the spindle.8.The spindle shall run in designated direction.9.The spindle shall be installed and fixed according to the relevant drawings and instructions.10.The temperature shall be within 22- -25C if water cooling machine is used.11.The spindle adopts v apor lock and the gas source shall not be used until it has passed oil-water separator and dry filter. The air pressure is 0.2-0.25MPa and the filering precision is 5 um ,otherwise there will cause damages to the bearing.